Instruction Manual C401/301/201/101/102/103/104/105 Portable Colorimeter TechnologyMadeEasy...68X357704 Rev 1 05/05
Measurement C401/301/201/101/102/103/104/105 Colorimeter 62 MEASUREMENT 2.1 General Information The waterproof C401/301/201/101/102/103/104/105 Co
Measurement C401/301/201/101/102/103/104/105 Colorimeter 72.2 Preparation of Sample Vial 1. Obtain a clean and dry sample vial (Figure 6). 2. T
Measurement C401/301/201/101/102/103/104/105 Colorimeter 84. Turn on the meter by pressing the ON/OFF key. 5. For the single-parameter colorimet
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 92.4 Chlorine, Free & Total (0 – 6ppm Cl2) • DPD method1 for Free Chlorine -
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 107. Remove the vial from the meter and add into it the content of one Chlorine,
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 11 Chlorine, Free & Total Measuring Hints & Tips 2.4.1 Sample Collection
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 12 Alkalinity: Greater than 250ppm CaCO3 may cause interference. To remove this in
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 13sample volume and the volume of neutralising reagent used: Final Volume = Initia
Measurement: Chlorine, Free & Total C401/301/201Colorimeter 14Bromine and Ozone, for details. 2.4.5 Chemistry Chlorine exists in water as U
Measurement: Cyanuric Acid C401/102 Colorimeter 152.5 Cyanuric Acid (5-90 ppm) • For water and treated water 1. Switch the meter on by pressing
Measurement: Cyanuric Acid C401/102 Colorimeter 16 Add content of one Cyanuric Acid Reagent Sachet Shake for1 minute 9. Gently push the v
Measurement: Cyanuric Acid C401/102 Colorimeter 17 Cyanuric Acid Measuring Hints & Tips 2.5.1 Sample Collection Samples may be collected in ei
Measurement: Cyanuric Acid C401/102 Colorimeter 18 To re-calibrate the meter: All instruments are factory calibrated and user calibration is not r
Measurement: pH C401/301/101 Colorimeter 192.6 pH (5.9-8.2 pH units) • For water and wastewater (Phenol Red Method) 1. Switch the meter on by pr
Measurement: pH C401/301/101 Colorimeter 20 Invert several times to mix. Add 20 drops of pH Indicator (Phenol Red) pHIndicator (
Measurement: pH C401/301/101 Colorimeter 21 2.6.1 Sample Collection Samples may be collected in either plastic or glass bottles. It is advisable
Measurement: pH C401/301/101 Colorimeter 22 2.6.5 Chemistry The monitoring and control of the pH of water is important in many different applicatio
Measurement: Chlorine Dioxide C103 Colorimeter 232.7 Chorine Dioxide (0 – 11.4 ppm ClO2) • DPD method1 for Chlorine Dioxide - applicable to wate
Measurement: Chlorine Dioxide C103 Colorimeter 24Chlorine Dioxide SampleREADENTERppm Add content of one Chlorine Dioxide (Glycine) Reagent
Measurement: Chlorine Dioxide C103 Colorimeter 25 Chlorine Dioxide Measuring Hints & Tips 2.7.1 Sample Collection Chlorine Dioxide determinatio
Preface This manual functions in two ways: first as a step by step guide to help you operate the waterproof C401/301/201/101/102/103/104/105 Colorimet
Measurement: Chlorine Dioxide C103 Colorimeter 26Acid to the sample before carrying out the above test procedure. Use a multiplication factor to c
Measurement: Chlorine Dioxide C103 Colorimeter 276. Subtract the result obtained in step 5 from the result obtained in step 1 to give the true res
Measurement: Chlorine Dioxide C103 Colorimeter 28average the results. The result obtained should be approximately the value of the standard used (p
Measurement: Bromine C104 Colorimeter 292.8 Bromine (0 – 13.5ppm Br2) • DPD method1 for Bromine - applicable to water, treated water, wastewater
Measurement: Bromine C104 Colorimeter 30 Add content of one Chlorine,Total (DPD) Reagent SachetInvert vial approximately 20 seconds until powder d
Measurement: Bromine C104 Colorimeter 31 Bromine Measuring Hints & Tips 2.8.1 Sample Collection Bromine determination must take place as soon
Measurement: Bromine C104 Colorimeter 32interference, neutralise a separate sample to pH6-7 using 1N Sulphuric Acid. Note the volumes used and add
Measurement: Bromine C104 Colorimeter 33Reagent. The result from a test can then be multiplied by the Correction Factor to give the true result.
Measurement: Ozone C105 Colorimeter 342.9 Ozone (0 – 4.1 ppm O3) • DPD method1 for Ozone - applicable to water, treated water, wastewater and sea
Measurement: Ozone C105 Colorimeter 35 Add content of one Chlorine,Total (DPD) Reagent SachetInvert vial approximately 20 seconds until powder diss
TABLE OF CONTENTS 1 INTRODUCTION...
Measurement: Ozone C105 Colorimeter 36 Ozone Measuring Hints & Tips 2.9.1 Sample Collection Ozone determination must take place as soon as poss
Measurement: Ozone C105 Colorimeter 37interference, neutralise a separate sample to pH6-7 using 1N Sulphuric Acid. Note the volumes used and add th
Measurement: Ozone C105 Colorimeter 38The result from a test can then be multiplied by the Correction Factor to give the true result. If reagents a
Calibration C401/301/201/101/102/103/104/105 Colorimeter 393 CALIBRATION The C401/301/201/101/102/103/104/105 Colorimeter was calibrated and tested
Calibration: Chlorine, Free & Total, Chlorine Dioxide, Bromine, Ozone C401/301/201/103/104/105 Colorimeter 403.2 Chlorine, Free & Total,
Calibration: Chlorine, Free & Total, Chlorine Dioxide, Bromine, Ozone C401/301/201/103/104/105 Colorimeter 41instrument, whilst aligning the ▼
Calibration: Chlorine, Free & Total, Chlorine Dioxide, Bromine, Ozone C401/301/201/103/104/105 Colorimeter 4216. Press the READ/ENTER key. Th
Calibration: Cyanuric Acid C401/102 Colorimeter 43OFFONZEROCALMODEPress Mode to select test parameter of “CYNA” for Cyanuric AcidBlanking SampleCAL
Calibration: Cyanuric Acid C401/102 Colorimeter 44Shake for1 minuteCyanuric Acid Sample 70 ppmppmREADENTERCALCALMODEREADENTERPress Mode to sele
Calibration: Cyanuric Acid C401/102 Colorimeter 45 NOTE: If you wish to abort this calibration process, do NOT press the READ/ENTER key as in step
Introduction C401/301/201/101/102/103/104/105 Colorimeter 11 INTRODUCTION Thank you for selecting the waterproof portable C401/301/201/101/ 102/10
Calibration: pH C401/301/101 Colorimeter 463.4 pH 1. Ensure at least 10 ml of clear pH7.0 buffer is available. 2. Ensure the meter is switched o
Calibration: pH C401/301/101 Colorimeter 47 10. Select another clean vial, un-screw the cap and fill it with 10 ml of the pH7.0 colorless buffer.
Calibration: pH C401/301/101 Colorimeter 48NOTE: If you wish to abort this calibration process, do NOT press the READ/ENTER key as in step 16. Pres
Restoring Factory Calibration C401/301/201/101/102/103/104/105 Colorimeter 493.5 Restoring Factory Calibration The C401/301/201/101/102/103/104/10
Restoring Factory Calibration C401/301/201/101/102/103/104/105 Colorimeter 50The meter is now ready for measurementREADENTERREADENTERPress MODE and
Troubleshooting Guide C401/301/201/101/102/103/104/105 Colorimeter 514 TROUBLESHOOTING GUIDE The C401/301/201/101/102/103/104/105 Colorimeter routi
Routine Maintenance C401/301/201/101/102/103/104/105 Colorimeter 525 ROUTINE MAINTENANCE The supplied carrying case is optimal for protecting the i
Accessories C401/301/201/101/102/103/104/105 Colorimeter 536 ACCESSORIES The items shown below are recommended accessories and replacement parts f
Specifications C401/301/201/101/102/103/104/105 Colorimeter 547 SPECIFICATIONS CHLORINE FREE & TOTAL Automatic Range Selection 0 – 1.99 ppm 2.
Specifications C401/301/201/101/102/103/104/105 Colorimeter 55 Measurement Method Photometric Light Source Light Emitting Diode (LED) Wavelengt
Introduction C401/301/201/101/102/103/104/105 Colorimeter 21.1 Unpacking C401/301/201/101/102/103/104/105 Colorimeter and Accessories The table b
Warranty and Return of Items C401/301/201/101/102/103/104/105 Colorimeter 568 WARRANTY The Colorimeters is supplied with a 2-year warranty from ma
For more information on Eutech Instruments/ Oakton Instruments’ products, contact your nearest distributor or visit our websit
Introduction C401/301/201/101/102/103/104/105 Colorimeter 3Sample VialSample WellMeter Index MarkingLiquid Crystal DisplayKeypad Figure 1: Parts o
Introduction C401/301/201/101/102/103/104/105 Colorimeter 41.3 Keys and Functions The keypad has four keys: ON/OFF, MODE, ZERO and READ/ENTER.
Introduction C401/301/201/101/102/103/104/105 Colorimeter 51.4 Battery Installation Four AAA-sized batteries are included in your meter’s packagi
Kommentare zu diesen Handbüchern